Ruger 10/22 BLACK charging bolt handle extension
Factory New Condition
FFL is not required
Current Bid
No Bids
BuyNow! Price Was
$8.00
Starting Bid
$8.00
No Reserve!
0 Bids Bid History
Time Left 15 min rule
Item has Ended
7/31/2017 8:21 PM
Item 670172610
Location South Portland, ME 04106
Shipping
1st Class$2.50
No international shipments
Payment PayPal
Checkout Yes
Sales Tax
Seller does not collect sales tax
Inspection/ Return Policy
AS IS - No refund or exchange

The seller of this item assumes all responsibility for this listing. You must contact the seller to resolve any questions or concerns before placing a bid. Payment must be made using U.S. dollars ($) unless otherwise stated in the listing. Firearms may only be shipped to a licensed dealer (FFL Holder). Some listed items may not be legal in every state. Complete your purchase within the law.

PLEASE NOTE, DO NOT PURCHASE THIS PRODUCT IF YOUR RUGER 10/22 BOLT HANDLE HAS A RECESSED RUGER EMBLEM. These models appear to have been made after October, 2014 and we are working on a solution.

From PredatorToolworks, these are cylindric bolt handle extensions that fit over the stock bolt handle of the Ruger 10/22, Marlin 60/70/795 with original cylindric bolt handles, or Mossberg Plinkster Tactical.

Please Note! THE ACTUAL FIREARM, STOCK ROD, SPRING, AND ORIGINAL STOCK BOLT HANDLE ARE NOT INCLUDED

Our bolt handle extensions look great, and make it extremely easy and comfortable to charge the bolt. No need to spend 40 dollars on the entire spring and armature - that's a total waste of money. These look and work great with any color stock and makes charging a pleasure, even with gloves.

-------------------------------------------------------------------------------------------------------------------------------------------------------------

Installation instructions - please read carefully! You will need a small amount of 24 hour cure standard gray epoxy - do not use quick setting epoxy. For best results on the Ruger and Mossberg you should remove the stock handle from the receiver to perform the following tasks:

Ruger and Mossberg:

1. Fill the PredatorToolWorks cylinder 1/4 with epoxy and place the filled end over the handle. If needed, tap with a wood mallet to snug fit and depth (or use a piece of wood to protect the finish from a regular hammer tap).

2. Fill the outward facing front of the handle to just below the top of the cylinder (or just above the end of the stock bolt handle - as desired). Use overnight curing epoxy so you can smooth it with the tip of your finger to just under the surface of the piece after about an hour to get that nice finished look.

3. Allow to set upright overnight.

Marlin fits over original cylindric handles only (models 60 / 70 / 795)

1. It is not necessary to remove the stock bolt handle. Lightly coat the stock handle with epoxy and place the PredatorToolworks cylinder over, wiping any excess off. Make sure you leave adequate clearance along the stock.

2. Allow to set overnight.

Please make payment via paypal to: sales@predatortoolworks.com

Thanks for your business!

Seller provided no "Additional Terms of Sale"
UPC
 
SKU
 
Mfg Part Number
 
Weight